Pinpoint
Exercises/Compare

Exercise Comparison

Backward Drag vs Barbell Squat To A Bench

Backward Drag - starting position
Backward Drag - ending position
Backward Drag
beginner·Other·compound
Barbell Squat To A Bench - starting position
Barbell Squat To A Bench - ending position
Barbell Squat To A Bench
expert·Barbell·compound

Side-by-Side

Backward Drag
VS
Barbell Squat To A Bench
beginner
Level
expert
Other
Equipment
Barbell
compound
Mechanic
compound
pull
Force
push
Strongman
Category
Strength
quadriceps
Primary
quadriceps
calvesforearmsgluteshamstringslower back
Secondary
calvesgluteshamstringslower back

Muscle Analysis

Shared

quadricepscalvesgluteshamstringslower back

Only in Backward Drag

forearms

Instructions

Backward Drag

1

Load a sled with the desired weight, attaching a rope or straps to the sled that you can hold onto.

2

Begin the exercise by moving backwards for a given distance. Leaning back, extend through the legs for short steps to move as quickly as possible.

Barbell Squat To A Bench

1

This exercise is best performed inside a squat rack for safety purposes. To begin, first place a flat bench or a box behind you. The flat bench is used to teach you to set your hips back and to hit depth.

2

3

Then, set the bar on a rack that best matches your height. Once the correct height is chosen and the bar is loaded, step under the bar and place the back of your shoulders (slightly below the neck) across it.

4

Hold on to the bar using both arms at each side and lift it off the rack by first pushing with your legs and at the same time straightening your torso.

5

Step away from the rack and position your legs using a shoulder width medium stance with the toes slightly pointed out. Keep your head up at all times as looking down will get you off balance and also maintain a straight back. This will be your starting position. (Note: For the purposes of this discussion we will use the medium stance described above which targets overall development; however you can choose any of the three stances discussed in the foot stances section).

6

Begin to slowly lower the bar by bending the knees and sitting your hips back as you maintain a straight posture with the head up. Continue down until you slightly touch the bench behind you. Inhale as you perform this portion of the movement. Tip: If you performed the exercise correctly, the front of the knees should make an imaginary straight line with the toes that is perpendicular to the front. If your knees are past that imaginary line (if they are past your toes) then you are placing undue stress on the knee and the exercise has been performed incorrectly.

7

Begin to raise the bar as you exhale by pushing the floor with the heel of your foot as you straighten the legs and extend the hips to go back to the starting position.

8

Repeat for the recommended amount of repetitions.

Verdict

Both exercises target the quadriceps. Backward Drag is a beginner exercise using other, while Barbell Squat To A Bench is expert and uses barbell. Choose Backward Drag if you're looking for a more accessible option, or Barbell Squat To A Bench for a greater challenge.

Pinpoint·Interactive 3D Anatomy & Exercise Guide