Barbell Bench Press - Medium Grip vs Incline Dumbbell Flyes - With A Twist

Lie back on a flat bench. Using a medium width grip (a grip that creates a 90-degree angle in the middle of the movement between the forearms and the upper arms), lift the bar from the rack and hold it straight over you with your arms locked. This will be your starting position.

From the starting position, breathe in and begin coming down slowly until the bar touches your middle chest.

After a brief pause, push the bar back to the starting position as you breathe out. Focus on pushing the bar using your chest muscles. Lock your arms and squeeze your chest in the contracted position at the top of the motion, hold for a second and then start coming down slowly again. Tip: Ideally, lowering the weight should take about twice as long as raising it.

Repeat the movement for the prescribed amount of repetitions.

When you are done, place the bar back in the rack.

Hold a dumbbell in each hand and lie on an incline bench that is set to an incline angle of no more than 30 degrees.

Extend your arms above you with a slight bend at the elbows.

Now rotate the wrists so that the palms of your hands are facing you. Tip: The pinky fingers should be next to each other. This will be your starting position.

As you breathe in, start to slowly lower the arms to the side while keeping the arms extended and while rotating the wrists until the palms of the hand are facing each other. Tip: At the end of the movement the arms will be by your side with the palms facing the ceiling.

As you exhale start to bring the dumbbells back up to the starting position by reversing the motion and rotating the hands so that the pinky fingers are next to each other again. Tip: Keep in mind that the movement will only happen at the shoulder joint and at the wrist. There is no motion that happens at the elbow joint.

Repeat for the recommended amount of repetitions.