Barbell Bench Press - Medium Grip vs Wide-Grip Decline Barbell Pullover

Lie back on a flat bench. Using a medium width grip (a grip that creates a 90-degree angle in the middle of the movement between the forearms and the upper arms), lift the bar from the rack and hold it straight over you with your arms locked. This will be your starting position.

From the starting position, breathe in and begin coming down slowly until the bar touches your middle chest.

After a brief pause, push the bar back to the starting position as you breathe out. Focus on pushing the bar using your chest muscles. Lock your arms and squeeze your chest in the contracted position at the top of the motion, hold for a second and then start coming down slowly again. Tip: Ideally, lowering the weight should take about twice as long as raising it.

Repeat the movement for the prescribed amount of repetitions.

When you are done, place the bar back in the rack.

Lie down on a decline bench with both legs securely locked in position. Reach for the barbell behind the head using a pronated grip (palms facing out). Make sure to grab the barbell wider than shoulder width apart for this exercise. Slowly lift the barbell up from the floor by using your arms.

When positioned properly, your arms should be fully extended and perpendicular to the floor. This is the starting position.

Begin by moving the barbell back down in a semicircular motion as if you were going to place it on the floor, but instead, stop when the arms are parallel to the floor. Tip: Keep the arms fully extended at all times. The movement should only happen at the shoulder joint. Inhale as you perform this portion of the movement.

Now bring the barbell up while exhaling until you are back at the starting position. Remember to keep full control of the barbell at all times.

Repeat the movement for the prescribed amount of repetitions of your training program.

When finished with your set, slowly lower the barbell back down until it is level with your head and release it.